My Garage Door Won’t Open – Help Me!

Posted by on Sep 20, 2016 in Garage Door Services |

Garage door openers are probably the most useful appliances that make our life easier at home. Bearing in mind that a garage door is the largest moving part of the house, garage door openers save us pounds of calories that we would have burned to make the door move. When a garage door fails to open, one gets so frustrated that they may think of crashing their way in. However, a garage door being stuck in closed position is sometimes not so much of a depressing issue.

If you are in a situation that makes you contemplate about your garage won’t open type of query, check the following and you will get the answers you are looking for. And if you happen to be in Arizona, check out Garage Doors At Chandler’s website for more info.

garage-lock1. Your garage door is in lock mode: If the opener keypad button is held for too long, this action can activate or deactivate the lock mode. When the garage door is in lock mode, you can’t open or close it. Before thinking about calling a specialist, make sure you hold the keypad button down a few seconds to deactivate lock mode then try opening the door.

2. Power source: The power source can cause garage door opening problems in two ways: One, the power source is unplugged, and two, the transmitter batteries have run out. While it might sound ridiculous, many people will forget that they unplugged their power source and keep wondering why the door isn’t opening. Check the power outlet and ensure that it’s working by plugging in another electronic device. Also check the fuse, circuit breaker or GFCI.

3. Sensitivity is out of adjustment: The garage door’s sensitivity should not be set too low or too high as the opener will not sense the weight of the door correctly. Use the manufacturer’s directions to test the sensitivity of your garage door. Limit switch to correct levels, adjust the close force and everything should be fine.

remote4. Malfunctioning remote control: If the door fails to open with the remote control, there could be a few explanations for this. One, motor’s antenna could be broken or blocked. Check to ensure that it is hanging down from the motor. Two, the remote’s battery could be weak and needs replacement. If these two solutions don’t help, reprogram the remote and try opening the garage door. Make sure you are within the range of the door.

5. Photo eye is dirty or out of alignment: Photo eyes are located at either side of the garage door. Between them there is an invisible beam. For the door to open or close, a photo eye has to send a laser across the beam to the other side of the length. If the eye is out of alignment or has become dirty, the door won’t move. Use the cleaning and inspecting guidelines on the manufacturer’s manual to solve this problem.

6. Track is out of alignment: Your door runs on a metal track which can present serious problems if it’s out of alignment. If there are gaps between the rail and rollers, the door’s weight can compound the issue and make operating the door dangerous. An expert’s help would be the only solution here.

7. Broken torsion springs: When garage door torsion springs break, don’t try to open the door unless you are a garage door expert and you have the right tools. Torsion springs are usually across the top and extension springs on either side of the garage door. They can only run for a limited number of cycles. If the cycles run out and the springs are not yet replaced, they snap or break. When this happens, call a specialist to replace them for you.

8. A stripped gear: The weight of a garage door can cause too much strain on the opener. While this happens, you will hear a humming noise when trying to open the garage door and the door won’t open. There are two ways around this issue: replace either the gears or the whole opener. If the opener is older than ten years and has been giving you trouble, it’s recommended that you replace it.

9. Lock handle: If your garage door has a lock handle, ensure that it is not engaged. An engaged lock handle manually locks the garage door making it impossible to open the door automatically. Unlock the door handle before trying to open the door.

CAUTION! Moving garage doors can cause deadly injuries to a person. If you are not sure or confident that you can handle your garage door, please seek the guidance of a garage door specialist.

Read More

What You Need To Know – Garage Door Springs

Posted by on Jun 6, 2016 in Garage Door Services |

Door springs are used to open and close a garage door. The extension spring and torsion spring are the two basic spring types. Although both springs are dangerous, torsion springs are trickier to handle and more dangerous than extension springs.

Extension springs are used specifically for lighter garage doors, such as one-piece tilt-up and sectional doors. They hang from the top of the door, and are anchored near the back of the upper tracks. If you want to install or repair your garage, you can do it yourself. However, extension springs are still dangerous if you are not attentive and follow the repair instructions.

Torsion springs are used for heavier doors, such as sectional doors. Torsion springs are used on both sides of the door. A professional must install or repair your garage if it uses torsion springs. They have been known to cause serious injuries and even some deaths.

Garage doors that use torsion springs can be a little hard to handle. They usually weigh anywhere between 300-400 pounds, so the springs must be powerful enough to open and close the door. These springs have caused serious head trauma to even professionals when they are being installed or repaired.

If you have children, educate them to never stand below the garage door when it’s opening or closing. Furthermore, you should install the buttons that open and close the door out of the reach of young children. This should prevent most accidents caused by the garage door or the door springs themselves. No matter how much you educate them, young children will want to push the button that opens/closes the garage out of curiosity.

Even the best maintained garage door springs will need to be repaired due to wear-and-tear. In order to prevent serious repairs, it’s wise to perform regular check-ups on your springs’ conditions. when one spring needs repair, the other is likely be get damaged soon after. Therefore, it’s best if you replace both springs together.

Repair and install costs range from $75-$350. Repairing and installing torsion springs fall at the higher end of the price range, so shop around and compare prices. However, price shouldn’t be the determining factor; make sure the professional does quality work. It might be worth it to pay a little more and avoid continual repairs.

Torsion springsThe door springs absorb the most tension while the door is closing. So, if the closed door fails to open due to a damaged spring, it will not injure anyone. If the spring broke while the door was open, it would fall and potentially injure someone, damage a car or the floor.

The durability of the garage spring is determined by various factors including maintenance, frequency of usage, compatibility with the garage door, and the quality of the spring itself.

Your garage door springs are powerful and dangerous mechanisms, that must be maintained properly. Make sure to inspect them periodically and ensure they are in excellent working condition. This will prevent many accidents due to the spring breaking or malfunctioning. Remember, if you are looking to replace your door springs it’s best to have a professional complete the repairs for you.

Almost every home today has a garage on the property. These people might have had the unfortunate incident of their car being stuck being a garage door that wouldn’t open. This is because they had bad door springs. When the spring went bad, the door got stuck. The only way to get the car out is to fix the garage door spring. Thankfully today you can find quality garage door springs that not only open and close the door, but have new security features that help to make your garage safer than ever before.

Faulty springAll door springs will need to be replaced in time. However, the better quality door spring you buy the longer it will last. Remember this is a part that is used every day in the operation of your garage. Anytime you need to open or close the door the door spring will be used. This stretches the hardened steel torsion spring device of the door. Eventually it will develop stresses and get over used. Then it will break and need to be replaced. It’s standard practice for people to replace both of the springs once one breaks. Since they get equal wear and tear the other will breakdown soon anyways so it’s really a time saver to get the job done all at once. Torsion springs will usually last for about 10,000 cycles or six years. It really depends on the amount of use they get.

The next type of garage door spring is the extension springs. This is responsible for raising the door by using a stretching action. This spring also usually lasts for about six years. Both types of these springs can be easily replaced and finding then is as simple as an online search. Be sure to perfect the best quality springs you can find to ensure that your garage door works correctly for a long time.

Read More